Fujitsu 770Tx User Manual page 169

This means that the fl oppy disk drive type iden-
tified in your Setup Utility does not agree with
the type detected by the Power On Self Test. Run
the Setup Utility to correct the inconsistency.
*Invalid NVRAM media type Problem with
NVRAM access. In the unlikely case that you
see this message you may have some display
problems. You can continue operating but
should contact your support representative for
more information.
*Keyboard controller error The keyboard con-
troller test failed. You may have to replace your
keyboard or keyboard controller but may be
able to use an external keyboard until then.
Contact your support representative.
*Keyboard error Keyboard not working. You
may have to replace your keyboard or keyboard
controller but may be able to use an ext ernal
keyboard until then. Contact your support
representative.
*Keyboard error nn BIOS discovered a stuck
key and displays the scan code for the stuck key.
T r o u b l e s h o o t i n g
You may have to replace your keyboard but may
be able to use an external keyboard until then.
Contact your support representative.
*Monitor type does not match CMOS – Run
SETUP Monitor type not correctly identified in
Setup. This error probably means your BIOS is
corrupted, run the Setup Utility and set all set-
tings to the default conditions. If you still get
this error, contact your support representative.
#*Operating system not found Operating sys-
tem cannot be located on either drive A: or
drive C:Enter the Setup Utility and see if fixed
disk and drive A:are properly identified and
that the boot sequence is set correctly. Unless
you have changed your installation greatly, the
operating system should be on drive C:. If the
setup utility is correctly set your hard drive is
probably corrupted and your system may have
to be re-installed from your back up media.
*Parity Check 1 nnnn Parity error found in the
system bus.BIOS attempts to locate the address
and display it on the screen. If it cannot locate
L i f e B o o k 7 0 0 S e r i e s f r o m F u j i t s u
the address,it displays ????. This is a potentially
data destroying failure. Contact your support
representative.
*Parity Check 2 nnnn Parity error found in the
I/O bus.BIOS attempts to locate the address
and display it on the screen. If it cannot locate
the address,it displays ????. This is a potentially
data destroying failure. Contact your support
representative.
#*Press <F1> to resume,<F2> to SETUP is
displayed after any recoverable error message.
Press the F1 key to continue the boot process
or the F2 key to enter Setup and change
any settings.
#*Previous boot incomplete – Default configu-
ration used Previous Power On Self Test did
not complete successfully. Power On Self Test
loads default values and offers to run Setup. If
the failure was caused by incorrect values and
they are not corrected, the next boot will likely
fail also. If using the default settings does not
allow you to complete a successful boot
159