Fujitsu 770Tx User Manual page 164

S e c t i o n F i v e
Problem
An error message is displayed on the screen
during the notebook turn on (boot) sequence.
Your notebook appears to change setup
parameters when you start it.
Video Problems
The built-in display is blank
when you turn on your notebook.
154
Possible Cause
1. Power On Self Test (POST) has detected
a problem.
1. BIOS setup changes were not saved when
you made them and exited the BIOS setup
utility returning it to previous settings.
2. The BIOS CMOS hold-up battery has failed.
1. Something is pushing on the Closed
Cover switch. (See Figure 1-7 on page 7.)
2. The notebook is set for an external
monitor only.
Possible Solution
1. See the Power On Self Test (POST) Messages
(pages 158-160) to determine the meaning and
severity of the problem. Not all messages are
errors; some are simply status indicators.
1. Make sure you select Save Changes And Exit
when exiting the BIOS setup utility.
2. Contact your support representative for
repairs. This is not a user serviceable part
but has a normal life of 3 to 5 years.
1. Clear the Closed Cover switch.
2. Pressing F10 while holding down the Fn key
allows you to change your selection of where
to send your display video. Each time you
press the combination of keys you will step
to the next choice. The choices, in order, are
built-in display only, external monitor only,
both built-in display and external monitor.