Landock - Fujitsu 770Tx User Manual

S e c t i o n F o u r
If the total memory displayed is not what you
believe it should be, check that your memory
upgrade module is properly installed. If it is
properly installed and the capacity is not cor-
rectly recognized,see the Troubleshooting
Section starting on page 138.
Undock Request Button
Ready to Undock LED
Docked LED
DC Power Jack
PS/2 Mouse Port
Headphone
Jack
PS/2 Keyboard Port
132
C A U T I O N
Follow the instructions that come with
your LANdock or Port Replicator. The
instructions and illustrations in this
manual are only to serve as a guideline.
The LANdock manual that is included
with the LANdock unit supersedes
these instructions.
RJ-11 Jack
RJ-45 Jack
Dual USB Ports
MIDI/Joystick Port
Serial Port
External Monitor Port
External Floppy
Disk Drive Port
PCCard Slot
Parallel Port
Figure 4-14 LANdock Rear View

LANDOCK

To Install your Notebook in a LANdock:
1. Put your notebook in Suspend mode or
turn off the power.
2. To use a docking device with your note-
book they both must be on a flat surface.
3. Remove all connections from the rear
panel of your notebook. (See Figure 1-9
on page 9.)
4. Make sure that the adjustment feet are flat
against the bottom of the notebook and the
covers of the connectors, both rear panel
and right side panel, are closed.
5. Make sure that the slide cover in the rear
panel is completely open.
6. Set your notebook on the Docking Station
Leveler, making sure that the Alignment
pins on the leveler (Figures 4-13 and 4-16.)
fit into the Docking Alignment receptacles
in the bottom of your notebook
(Figure 1-10 on page 10.)