Netcommander Server Interface Units - Tripp Lite NetCommander B070-008-19 Owner's Manual

Installation
NetCommander Server Interface Unit (SIU)
The NetCommander Server Interface Unit
The Server Interface Unit gets its power from the connected computer. In the case of the
NetCommander PS/2 Server Interface Unit (B078-101-PS2), the power is drawn from the
keyboard port. In the case of the NetCommander USB Server Interface Unit (B078-101-
USB), the power is drawn from the USB port. When connected and receiving power, the
green LED on the SIU will illuminate. When connected to the active port on the KVM, the
orange LED will illuminate.
Connecting a NetCommander PS/2 Server Interface Unit (Model # B078-101-PS2)
1. Shut down the computer being connected to the B078-101-PS2 (SIU)
2. Connect the B078-101-PS2 VGA connector to the computers VGA port
3. Connect the B078-101-PS2 PS/2 Keyboard connector to the computers PS/2 Keyboard port
4. Connect the B078-101-PS2 PS/2 Mouse connector to the computers PS/2 Mouse port
5. Connect one end of the Cat5 patch cable to the RJ45 port on the B078-101-PS2*
6. Connect the other end of the Cat5 patch cable to the desired RJ45 port on the
Console KVM.* The green LED will illuminate when connected and receiving power.
7. Repeat these steps for each additional PS/2 computer/server you are connecting to the
Console KVM
(continued)
Up to 100 ft
SIU = Server Interface Unit
Figure 4 NetCommander PS/2 Server Interface Unit
6