Heatmaster Enviro Troubleshooting Manual

The Trouble shooting - Heatmaster enviro
Issue
Unit not starting
Turning on 1 - 3 sec
ALL PLUMBING AND ELECTRICAL WORK TO BE CARRIED OUT BY A QUALIFIED TECHNICIAN
FOR FURTHER INFORMATION PLEASE
CONTACT YOUR LOCAL DEALER.
ALL PLUMBING AND ELECTRICAL WORK
TO BE CARRIED OUT BY A QUALIFIED
TECHNICIAN
Cause
1. Insufficient power
2. Igniters and or sensor is
shorting out
3. Desired temperature is set
below room temperature
1. Soot build up on flame
sensor
2. Insufficient power
Heatmaster Pty Ltd
Email: sales@heatmaster.com.au
Website: www.heatmaster.com.au
ACN 006 442 717 ABN 64 641 709 587
Solution

Turn on isolation switch

Clean soot off
igniters/sensor and make
sure they are running
parallel with burner
(see below)

Increase desired room
temperature
Be sure no pebbles
or the pebble racks
come in contact with
the two igniters
(running to the right)
and the flame sensor
(running to the left)
This may cause the unit
to malfunction

Clean flame sensor with
a dry cloth

Make sure no extension
cord or power board are
being used.