Heatmaster Enviro Control Manual

* It is important to note that for
15 minutes after using your Enviro remote,
a signal is transmitted from the thermostat which
overides the manual controls. To avoid this you can simply turn
off the power (at the isolation switch) for approx. 2 min before using the manual controls.
Step 1
Ensure that the power supply to the firebox is switched on.
Step 2
To ignite your Enviro press the power on/off button(top left). This will begin the ignition
sequence which will purge the air from the firebox for approx. 30 seconds before
igniting the burner.
Step 3
The heater will start in the low setting for approx 2 minutes before automatically
jumping to the maximum setting.
Step 4
To reduce the fan/flame setting press the top right button. To increase the fan/flame
press the bottom right button.
*The fan and flame are connected which means that reducing or increasing the
flame will also reduce or increase the fan speed.
Step 5
to turn your Enviro off, simply press the on/off button.
pleaSe note:
Fan will continue to run until firebox cools down.
This is a basic guide only for complete instructions on the use of your Enviro refer to the Customer operating
information & instruction guide along with the 7000 series thermostat user manual.
www.heatmaster.com.au
–
ON/OFF
POWER FAN
+
–
FLAME
+