Wrist Positioning Guide Settings; Date & Time Set Procedure; Applying The Cuff - Walgreens WGNBPW-920 Manual

WRIST POSITIONING GUIDE SETTINGS

1. To turn the Wrist Positioning Guide OFF or ON, press and
hold the START/STOP button for 3 seconds.
Note:
By default, the Wrist Positioning Guide is ON.
2. The display will show a blinking ON. To turn it OFF, press
and hold the START/STOP button again for 3 seconds.
DATE & TIME SET PROCEDURE
1. To adjust the date and time, press the DATE/TIME SET
button located on the side of the monitor.
2. The display will show a blinking number showing the
MONTH. Change the MONTH by pressing the + button.
Each press will increase the number by one in a cycling
manner. Press the DATE/TIME SET button
confirm the entry, and the screen will show a blinking
number representing the
DAY.
3. Change the DAY, YEAR,
HOUR, & MINUTE as
described in Step 2.
above, using the +
button to change
the numbers and the
DATE/TIME SET button
to confirm the entries.
again to
Press the button
blinking HOUR
increasing HOUR
confirm the entry
repeat process to set HOUR, MINUTE,
MONTH, DAY and YEAR
15

APPLYING THE CUFF

1. Remove all watches, wrist jewelry, etc. prior to attaching
the wrist monitor. Clothing sleeves should be rolled up
and the cuff should be wrapped around bare skin for
correct measurements.
2. Apply cuff to left wrist with
palm facing up as shown in
Fig. A.
3. Make sure the edge
of the cuff is about
1/4"~1/2" (1 cm) from the
palm as shown in Fig. B.
Fig. A
Fig. B
16