Table of Contents
Advertisement
3. Selecting Installation Position / 選擇安裝位置 (continued / 續)
■ Requirements during installation
■ 安裝期間要求
[Main unit / 主機]
- Install the main unit in the mounting frame
from inside the bathroom. (Otherwise lowering
the main unit for maintenance becomes
impossible)
- 從浴室內部將主機安裝在安裝架中。(否則無法降低
主機以執行維護)
4. Method of Installation / 安裝方法
Installation procedure
安裝步驟
Preparations for installation
1
安裝準備
Installing the main unit
2
安裝主機
Electrical work
3
電氣作業
Attaching the panel
4
安裝面板
Installing the remote controller
5
安裝遙控器
Adjusting the horizontal air direction
6
調整水平風向
Checks after installation
安裝後檢查
Trial operation
運轉試驗
↓
↓
↓
↓
↓
↓
↓
[Others / 其他]
- To use this product for general ventilation of
the house requires ventilation measures (such
as an undercut) in the door of the room.
- Do not use an impact driver to tighten the
screws in the panel or the cable clips for the
power cable. Tighten by hand.
- Provide an air vent.
- 若要將本產品用於房屋的一般換氣，需要針對房門
採取換氣措施(例如底切)。
- 請勿使用衝擊起子緊固面板中的螺絲或電源線的線
夾。請用手緊固。
- 提供排氣口。
Preparations for installation
1
安裝準備
Warning / 警告
To install the product, make a mounting
frame out of aluminium and secure it with
screws. Use aluminium materials that
conform to "Buildings Department Practice
Notes for Registered Contractors 47
(Aluminium window)".
Failure to do so may fall and cause an injury.
若要安裝產品，請使用鋁製安裝架並用螺絲
固定。使用符合「屋宇署註冊承建商作業備
考47(鋁窗)」的鋁材。
否則可能會墜落並造成傷害。
The maximum length of the mounting
frame is 600 mm.
Failure to do so may fall and cause an injury.
安裝架的最大長度為600 mm。
否則可能會墜落並造成傷害。
Caution / 注意
Install securely in a place with sufficient
strength.
It could fall and cause an injury.
牢固安裝到有足夠強度的位置。
可能會墜落並造成傷害。
6
Advertisement
Table of Contents
