2001876H31301 MITSUBISHI ELECTRIC LOSSNAY ENERGY RECOVERY VENTILATOR MODEL VL-100ZSKRT-E (Remote Controller Model) Operating Instructions For Customer Contents Page Safety precautions ......2 Features ..........4 When using the unit ......4 Names of parts ........5 Before you start the Lossnay ..... 6 Operation ...........
Safety precautions The following symbols indicate the degree of danger Symbols used in the text and on the main unit have the caused by incorrect handling of the product. following meanings. Do not install in Warning Caution Prohibited bathroom Incorrect handling may Incorrect handling may result Do not touch Be sure to ground...
Page 3
If an abnormality or failure occurs, immediately stop use and turn off the power supply isolator. Continuing use may result in smoke, fire, electric shock, or injury. <Examples of abnormalities/failures> - Pressing the switch does not start the rotation of rotors. - There is unusual noise or vibration during rotation.
Safety precautions Handling the remote controller battery Observe the following instructions to ensure safe use of the remote controller and correct use of the remote controller lithium battery. Caution Do not leave the battery and remote controller in a location that is accessible by small children. Accidental swallowing may cause chemical burns.
Names of parts ■Main unit controller Operation lamps: Green * The operation lamps are off immediately after power is supplied to the unit. The lamps turn on only when the button on the OFF/ON remote controller is set to ON during operation. Wire Panel frame * When the...
Before you start the Lossnay 1. Preparing to turn the power on 3. Installing the remote controller holder Turn the power supply isolator on at the distribution Secure the remote controller holder with the board. supplied mounting screws. - We do not recommend that you operate the unit with Power supply the remote controller placed in the remote controller isolator...
Operation Press the buttons to operate. Turning on or off the operation lamps Switching the air volume to “HIGH” on the main unit Press the button. HIGH Press the button. - The main unit switches to the HIGH OFF/ON - Each press of the button switches the operation.
Maintenance 4. Removing the filter from the frame To maintain the Lossnay function for a long period of time, clean the filter to remove the adhered dirt and (1) Push the tabs in three locations on the side of dust when the filter maintenance notification lamp the filter frame with a pick, etc.
Page 9
Cleaning the panel and panel frame Assembling and checking after maintenance When the panel and panel frame are getting dirty, wipe off the dirt with a cloth soaked in kitchen neutral detergent diluted with lukewarm water (40°C Caution or less) and then wipe them with a dry cloth to remove the detergent residue.
Troubleshooting Perform an inspection if any of the following symptoms occur. If the problem is not solved by an inspection or if the symptom is not in the table below, turn off the power supply isolator and ask the dealer or contractor for inspection and repair. Phenomenon Cause Inspect...
After-sales servicing Consult with your dealer about the after-sales If you hear strange sounds, if no air is blown out services provided for this Lossnay product. or if some other trouble occurs, switch off the power and contact your dealer. Consult with your dealer concerning the cost of inspection or repair work.
Air exhaust Air supply Cooling Heating High 38.5 13.5 High VL-100ZSKRT-E 25.5 High 41.5 16.5 * The noise values may be greater than those above depending on the room structure. Manufactured by: MITSUBISHI ELECTRIC CORPORATION TOKYO BLDG. 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO, 100-8310 JAPAN...