Advertisement
Quick Links
Contents:
How it Works . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Before Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installation Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
In-Vehicle Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Outside Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Signal Booster . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Cellular Cradle Plus . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Ultra Slim Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Powering Up the Signal Booster . . . . . . . . . . . . . . . . . . . . . . 7
In-Building Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Warnings and Recommendations . . . . . . . . . . . . . . . . . . . . . 9
Guarantee and Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Signal Booster Specifications . . . . . . . . . . . . . . . . Back Cover
Appearance of device and accessories may vary.
Note: This manual contains important safety and operating information.
Please read and follow the instructions in this manual. Failure to do so
could be hazardous and result in damage to your Signal Booster.
SIGNALBOOST™
Dual-Band Mobile
Signal Booster
(811510 is single band)
Advertisement
Related Manuals for Wilson Electronics SIGNALBOOST 811510
Summary of Contents for Wilson Electronics SIGNALBOOST 811510
-
Page 1: Table Of Contents
SIGNALBOOST™ Dual-Band Mobile Signal Booster (811510 is single band) Contents: How it Works ........1 Before Getting Started . -
Page 2: How It Works
Installation Instructions for the Following Wilson Electronics Signal Booster: Before Getting Started SIGNALBOOST™ Dual-Band Mobile Signal Booster This guide will help you properly install your Wilson Electronics SIGNALBOOST™ Dual-Band Signal Booster. It is important to read through all of the installation steps Model #811210 for your particular application prior to installing any equipment. - Page 3 Cradle. the Cradle. Gently slide the arm down until the arm is firmly in place. Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST.
- Page 4 ¼ inch into place. 866-294-1660. To Signal Booster Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST.
-
Page 5: Powering Up The Signal Booster
Then attach the Cellular Cradle Plus or Ultra Slim to your cell phone or data card. (See page 5 & 6.) Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST. -
Page 6: Warnings And Recommendations
Antenna) cables are attached to the Signal Booster. number supplied by Wilson Electronics. Wilson Electronics shall, at its option, either repair or replace the product. Wilson Electronics will pay for delivery of the repaired or replaced product back to the original consumer if located in the USA. -
Page 7: Signal Booster Specifications
Signal Booster Specifications Dual-Band Specifications Model Number 811210 Connectors FME-Male Impedance (input/output) 50 Ohms Dimensions 5 x 3.5 x 1.2 inch or 12.7 x 8.9 x 3 cm Weight 1.03 lbs or 0.468 kg Frequency 824-894 MHz / 1850-1990 MHz Passband Gain (nominal) 800 MHz (uplink/downlink) 25 dB / 25 dB...