Download Print this page

Wilson Electronics SIGNALBOOST 811510 Installation Manual page 3

Dual-band mobile signal booster

Advertisement

Installing the Outside Antenna
Carefully
Run Cable
Pull Down
Under
Door Seal
Seal
Tuck Cable
Under Seal
3
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
In-Vehicle
To receive the best cell signal, select a
location in the center of the vehicle's roof
that is 12 inches away from any other
antennas and free of obstructions. The
antenna must be installed vertically. Signal
performance will be degraded if the antenna
is not vertical.
!
Warning: The antenna used with this Signal
Booster must have a separation distance of
at least 12 inches from all persons.
The antenna cable may run through the
door to the Signal Booster. For a more
professional looking installation, run
the antenna cable under the door seal.
Carefully pull down the door seal. Run the
cable through the seal and push the seal
back into place. This prevents constant
wear and tear on the cable as the door
opens and closes.
The antenna cable is small enough to easily
tuck under the door seal or plastic molding.
Hours: 7am to 6pm MST.
Installing the Wilson Electronics Signal Booster
Adjusting the Cradle Plus Arms
Included with your Cradle Plus are various sized arms, which will provide you with multiple
options to customize the Cradle to fit your phone.
1. Change arms
Gently grab the arm and lift upward until
the arm slides free from the Cradle.
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
In-Vehicle
Select a location to install the Signal
Booster that is away from excessive heat,
direct sunlight or moisture and that has
proper ventilation.
Recommended installation locations for the
Signal Booster are:
• Under the seat
• Under the dash
Run the cable from the Outside Antenna
and attach it to the connector labeled
"Outside Antenna" on the Signal Booster.
!
Warning: Do not plug in the DC power
supply until the Outside Antenna and
Cellular Cradle Plus or Ultra Slim Antenna
cables are attached to the Signal Booster.
Attach the cable from the Cellular Cradle
Plus or the Ultra Slim Antenna to the
connector on the Signal Booster.
!
Warning: Do not plug the Signal Booster
directly into the cell phone or cellular data
card using an antenna adapter. It could
damage the Signal Booster, cell phone
and/or cellular data card.
2. Reposition arms
Position the arm above a different slot on
the Cradle. Gently slide the arm down until
the arm is firmly in place.
4
Hours: 7am to 6pm MST.

Advertisement

loading

This manual is also suitable for:

Signalboost 811514Signalboost 811710Signalboost 811714Signalboost 811910Signalboost 811914Signalboost 811210