Table of Contents
Advertisement
REMOTE CONTROL*
Key Button
Menu Access and Control
Zoom Function Control
ID Buttons
Motion Alarm ON&OFF
<Remote Control Picture>
NOTE :
Press [KEY] + [ID] (Default is "001" for ID=1)
Press [ENT] to access the Menu
Note : The camera ID is a 3-digit number.
42
REMOTE CONTROL Instructions
1) Set the camera ID in OSD menu.(The default setting is "001")
NOTE : If the camera ID is modified, the new camera ID must
be set, and the power must be turned ON and OFF. Then the
camera is able to recognize the new ID.
2) Press the "KEY" and the camera turns into the standby image.
The LED flickers for 20 seconds.
3) Input ID number of CAMERA to Remote Controller ID number.
After you input the ID number, LED light is turned on, and the
remote controller is ready to set the camera.
NOTE : The ID number must be 3-digit.
4) ZOOM IN (+) / ZOOM IN (-) Key
These are for controlling lens zoom, and selecting the zooming
area of alarm function.
5) Select the desired area where you wish to observe the movement of
objects. And then select the zooming range by pressing "7" wide key.
6) Please save alarm generating zooming range by "8" tele key.
If ALARM generating zoom range is smaller than ALARM
standby range, ALARM Zoom range setting will not be saved.
7) If select "9" ON/OFF key, product operates automatically
from tele to wide 1 time, and then the alarm function starts.
8) Please press "9" key to cancel the alarm function or to
reselect the alarm zooming area.
Advertisement
Table of Contents
