Table of Contents
Advertisement
Diagnosing connection problems
This section describes some connection problems you may encounter with your HomePortal home network
and provides suggestions for solving those problems. If the problem you are having is not covered here or
in the 2Wire online Help system, or if the suggestions provided do not solve the problem, call the
Technical Support number provided with your HomePortal.
POWER indicator light is not lit
If the
indicator light is not lit, the HomePortal is not getting power:
POWER
Check to see if the power cable is plugged into the power outlet or power strip.
1.
If the power cable is plugged into a power strip, make sure the power strip is turned on.
2.
Make sure the power cord is correctly and securely connected into the HomePortal.
3.
Verify that both ends of the power cord are firmly plugged into the brick.
4.
Note:
If the
indicator light is red (signifying a system error), or does not light after performing
POWER
the steps above, contact 2Wire Customer Care.
BROADBAND LINK indicator light is red
If the
BROADBAND LINK
DSL service provider:
Verify that a telephone cord is plugged into the
1.
telephone wall jack with DSL service.
Verify that you have configured the HomePortal with the correct settings (for example, username and
2.
password) provided by your DSL service provider.
Verify that DSL service is activated by calling your DSL service provider.
3.
LOCAL NETWORK indicator light is not lit
If your networked computers are powered on and the
HomePortal may not have been connected correctly. Double check the connection diagrams for your
particular connection type against your completed HomePortal setup.
indicator light is red, the HomePortal has not established a connection to your
port on the HomePortal and into the
PHONE
LINE
indicator light is not lit, the
LOCAL NETWORK
20
Advertisement
Table of Contents
