Configuring Broadband Connection - 2Wire 2710HGV-TNZ User Manual

Configuring Broadband Connection

Your Telecom Business gateway is already configured with DSL and Internet connection settings to
provide internet connectivity "out of the box" and does not require further configuration changes
unless specific Business services such as a Static IP address or port-forwarding functionality etc is
required.
The following information is provided should you need to manually configure your DSL and Internet
connection settings to work on the Telecom Broadband network:
Circuit identifier (VPI/VCI)
Encapsulation method
Connection Type
PPP username [Default]
PPP password
WARNING: Modifying the gateway broadband configuration settings may impede or
interrupt your broadband service. Modify these settings only if you are thoroughly
familiar with networking technology.
This section provides instructions to
• Configure DSL and ATM settings on
• Adjust the upstream rate on
• Configure the connection type on
• Configure PPP authentication settings on
• Modify the broadband IP on
• Add new DNS names on
• Change to the bridge mode on
0,100
Routed VC-Mux
PPPoA
user@xtrabb.co.nz
<anything you like with 6 or more characters>
page 74
page 76
page 76
page 77
page 78
page 80
page 82
73