Summary of Contents for HIKVISION ColorVu DS-2CE72DFT-FC
Page 1
TURBO HD Full Time Color Series Turret Camera User Manual User Manual Thank you for purchasing our product. If there are any questions, or requests, do not hesitate to contact the dealer. This manual applies to the models below: Model DS-2CE72DFT-FC This manual may contain technical mistakes or printing errors, and the content is subject to change without...
Page 2
Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Page 3
Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions”. Warnings: Serious injury or death may occur if any of the warnings are neglected.
Page 4
Keep the camera away from liquid while in use for non-water-proof device. While in delivery, the camera shall be packed in its original packing, or packing of the same texture. Mark Description Table 0-1 Mark Description Mark Description DC Voltage 1 Introduction 1.1 Product Features...
2 Installation Before you start: Make sure that the device in the package is in good condition and all the assembly parts are included. Make sure that all the related equipment is power-off during the installation. Check the specification of the products for the ...
Page 6
Expansion Bolts Self-tapping Screws Figure 2-2 Attach the Mounting Base to the Ceiling Note: The supplied screw package contains self-tapping screws, and expansion bolts. For cement wall/ceiling, expansion bolts are required to fix the camera. For wooden wall/ceiling, self-tapping screws are required.
Page 7
Figure 2-5 Drill Template of the Junction Box Note: Drill the cable hole, when adopting the ceiling outlet to route the cable. 3. Take apart the junction box, and align the screw holes of the turret camera’s mounting base with those on junction box’s cover.
3 Menu Description Follow the steps below to call the menu. Note: The actual display may vary with your camera model. Steps: 1. Connect the camera with the TVI DVR, and the monitor, shown as the figure 3-1. Figure 3-1 Connection 2.
3.1 FORMAT You can set the video format as 2MP@25fps, or 2 MP@30fps. 3.2 EXPOSURE EXPOSURE describes the brightness-related parameters, which can be adjusted by EXPOSURE MODE, AGC, and SLOW SHUTTER. Figure 3-3 AE EXPOSURE MODE You can set the EXPOSURE MODE to GLOBAL, BLC, or WDR.
Page 10
VIDEO SETTINGS WHITE BALANCE BRIGHTNESS CONTRAST SHARPNESS SATURATION 3 DNR MIRROR BACK EXIT SAVE & EXIT Figure 3-4 VIDEO SETTING WHITE BALANCE White balance, the white rendition function of the camera, is to adjust the color temperature according to the environment. It can remove unrealistic color casts in the image.
Page 11
HV: The image flips 180° both horizontally and vertically. 3.4 SMART LIGHT Under the SMART LIGHT sub-menu, you can set the mode to AUTO or OFF Figure 3-6 SMART LIGHT AUTO Under the AUTO mode, the white light turns on automatically as the environmental illumination becomes poor.
MOTION MODE AREA 0 AREA 1 AREA 2 AREA 3 SENSITIVITY COLOR TRANSPARENCY BACK EXIT SAVE & EXIT Figure 3-8 MOTION Select a MOTION area. Set the MODE to ON. Click the up/down/left/right button to define the position, and the size of the area.