Video Intercom Face Recognition Door Station User Manual
Note
•
The door-unlocked duration ranges from 1 s to 255 s.
•
If you check Upload Alarm for Not-Closed Door, an alarm will be triggered
automatically if the door is not locked in the configured duration.
•
Enabling Card Encrypt, the door station can recognize the encrypted
information of the card when you swiping the card on the door station.
3. Set the Elevator Control parameters.
1) Select an elevator No., and select an elevator controller type for the elevator.
2) Set the negative floor.
3) Select network interface as interface type. Enter the elevator controller's IP
address, port No., user name, and password.
4) Enable the elevator control.
Note
•
Up to 4 elevator controllers can be connected to one door station.
•
Up to 10 negative floors can be added.
•
Make sure the interface types of elevator controllers, which are connected
to the same door station, are consistent.
I/O Input and Output
Steps
1. Click I/O Input and Output to enter the I/O input and output settings page.
2. Select I/O input No., input mode, output No., and output mode.
3. Click Save to enable the settings.
Figure 6-11 I/O Input and Output
33