Table of Contents
Advertisement
Video Intercom Face Recognition Door Station User Manual
6 Configuration via Client Software
6.1 Edit Network Parameters
To operate and configure the device via LAN (Local Area Network), you need connect
the device in the same subnet with your PC. You can edit network parameters via
iVMS-4200 client software.
Steps
1. Select an online activated device and click the Modify Netinfo.
2. Edit the device IP address and gateway address to the same subnet with your
computer.
3. Enter the password and click OK to save the network parameters modification.
Note
•
The default port No. is 8000.
•
The default IP address of the door station is 192.0.0.65.
•
After editing the network parameters of device, you should add the devices
to the device list again.
6.2 Add Device
You should add device to the software so as to configure the device remotely.
6.2.1 Add Online Device
Before You Start
Make sure the device to be added is in the same subnet with your computer.
Otherwise, please edit network parameters first.
Steps
1. Click Online Device to select an active online device.
2. Click Add.
3. Enter corresponding information, and click Add.
22
Advertisement
Table of Contents
