Canon DR-S130 User Manual page 101

Item Description
Enable/disable multicast DNS.
This setting allows scanning
applications to search for and
automatically connect to the
scanner.
mDNS This is normally enabled.
When the setting is disabled, you
must manually specify the scanner
using its assigned IP address to
scan from the scanning
application.
SNMP Setting
If you click [SNMP Setting] on the Device Configuration screen, the
page below is displayed.
Default Value Item
SNMP
Service
Location
ON
Security -
Auth trap
SNMP v1
Community
Setting
SNMP v3
User Setting
101
Description
Sets the SNMP function to
enabled/disabled.
Input the location where the
scanner is installed.
Sets the SNMP authentication trap
function to enabled/disabled. By
setting this to [ON], if an SNMP
request is received from a
community that is not registered in
[Community Setting], then a
message is sent to the trap
destination.
Sets the SNMP v1 support function
to enabled/disabled.
Moves to the [Community Setting]
screen.
Sets the SNMP v3 support function
to enabled/disabled.
Moves to the [User Setting] screen. -
Default Value
OFF
None
OFF
OFF
-
OFF