Advertisement
Available languages
Available languages
Operating Dial
The operating dial has three settings:
1.
Dispensing steam/hot water via the steam nozzle
2.
Pump switched off / neutral position
3.
Pump switched on: dispensing espresso via the boiler outlet
4. As soon as the operating dial is turned from its neutral position, either the steam
nozzle or boiler outlet will open, and steam or hot water will be emitted.
Before Using For The First Time
Before the appliance is used for the first time, all detachable parts must be thoroughly
cleaned as described in the section "Care and Cleaning". Refit the drip tray and drainer
to the appliance afterwards. Clean the system by flushing with hot water as follows:
1.
Fill the container with water.
2.
Insert the filter holder with the filter sieve, but without putting any ground coffee in.
3.
Place a container, e.g. a suitably sized cup, underneath the outlet openings.
4.
Insert the plug into a wall outlet.
5.
Set the hot-water/steam selector to the hot- water position (button released).
6.
Use the On/Off switch to turn the appliance on, and activate the operating dial
(position
).
7.
Hot water is emitted from the outlets.
8.
Leave the pump running until about half the water in the water container has
passed through.
9.
Then switch off the pump by turning the operating dial to its neutral position.
10. Empty the cup and place it under the steam nozzle. Turn the operating dial to
position
.
11. Water is now emitted through the steam nozzle.
12. Let the water pass through until the amount left in the container has reached the
'Min. ' mark.
13. Switch off the pump by turning the operating dial to its neutral position.
14. This procedure should also be followed if the appliance has not been used for an
extended period of time.
EN
5
Advertisement
