Advertisement
Available languages
Available languages
Reheating beverages
•
Push the hot-water/steam selector button in.
•
Insert the steam nozzle into the liquid to be reheated and turn the operating dial
to the
position.
•
Once the liquid has reached the desired temperature turn the operating dial back
to its neutral position.
•
When steam is no longer needed, release the selector button again.
Care and Cleaning
•
Before cleaning the espresso maker, ensure it is disconnected from the power
supply and has cooled down completely.
•
To avoid the risk of electric shock, do not clean the appliance with water and do
not immerse it in water.
•
Do not use abrasives or harsh cleaning solutions.
•
Before cleaning the appliance, and also in the case of the appliance remaining
unused for an extended period of time, the remaining water in the container
should be drained completely. The water container should be thoroughly rinsed at
regular intervals.
•
The steam nozzle must be cleaned immediately after the frothing process. Wiping
the nozzle with a wet cloth should suffice.
•
If the steam nozzle becomes blocked, proceed as follows:
*
Pull the milk frother off the steam nozzle.
*
Unscrew the nozzle from the steam tube, using the measuring scoop as a
tool.
*
Insert a fine pin or needle into the steam nozzle to remove the blockage.
*
Screw the steam nozzle back onto the tube.
*
Push the milk frother back onto the nozzle.
•
All removable parts may be cleaned with warm, soapy water.
•
Always empty the drip tray in good time. Tray and drainer may be cleaned with
warm, soapy water.
•
The exterior housing may be wiped with a dry or slightly damp, lint-free cloth.
•
The boiler outlet may be wiped with a moist cloth.
•
The gasket area around the boiler outlet (at the bayonet locking socket) should be
cleaned using a brush. A hard brush is recommended.
EN
11
Advertisement
