Special Mode; Before Using For The First Time; Setting Up And Connecting The Coffee Machine; Filling With Water - Electrolux ECG6200 Instruction Book

4

Special mode

For setting the water hardness („Set-
ting the water hardness", page 55) and
the coffee temperature („Setting the
coffee temperature", page 61), for
starting the descaling program („Run-
ning the descaling program", page 63)
and for viewing the statistics („Statistic
mode", page 67), you can switch to a
special mode by pressing the "P" key
(Fig.4). In this mode, you can navigate
by means of the "1 cup of coffee"
"2 cups of coffee"
"P" keys. The respective function in
each case is shown in the display above
the key (Fig. 5):
• «<» ("1 cup of coffee"
«>» ("2 cups of coffee"
"scrolling"
• «OK» ("Steam"
• «P» ("P") returns to the last level with-
out changing settings.
5 Before using for the first
time
5.1 Setting up and connecting the
coffee machine
0 Place the machine on a suitable hori-
zontal, stable, unheated and water-
resistant surface.
Ensure that there is good air circula-
1
tion. After positioning the appliance
on the work top, leave a space of at
least 5 cm between the surfaces of the
appliance and the side and rear walls
and at least 20 cm above the coffee
maker.
Never install the appliance in environ-
ments where the temperature may
reach 0°C or lower (the appliance may
be damaged if the water freezes).
Important! If the coffee machine is
1
brought into a warm room from a cold
environment, wait about two hours
before switching on!
5.2
,
, "Steam" and
) and
) are for
) confirms an item
5.3
We advise you to place the coffee
machine on a suitable mat to prevent
damage being caused by spray and
splashes.
0 Plug the coffee machine into an
earthed mains socket. Do not use a
socket that is not earthed.

Filling with water

Each time before switching on the cof-
fee machine, check that there is water
in the water tank, and refill if neces-
sary. The coffee machine requires water
for the automatic rinsing processes
each time the machine is switched on
or off.
0 Remove the water tank from the cof-
fee machine (Fig. 6). Before the tank is
removed, the steam nozzle must
always be positioned towards the cen-
tre of the appliance, otherwise the
tank cannot be removed.
0 Fill the water tank with fresh cold
water. Never exceed the MAX line.
Pour only fresh cold water into the
3
water tank. Never put in other liquids,
e.g. mineral water or milk.
0 Replace the water tank (Fig. 6). Press
the tank firmly in, to ensure that the
water tank valve opens.
3 To always be sure of obtaining a rich
coffee with a full aroma, you should:
– change the water in the water tank
daily,
– wash the water tank at least once a
week in normal washing-up water
(not in the dishwasher). Then rinse
with fresh water.

Filling the coffee bean container

0 Raise the lid of the coffee bean con-
tainer, and fill the container with fresh
coffee beans (Fig. 7). Then reclose the
lid.
g
53