Advertisement
Available languages
Available languages
Operation
EN
Filling with water
Fill only with fresh water on a daily basis; make sure that the water container is
cleaned at regular intervals. Do not switch the appliance on unless the water
container is filled.
*
Lift up the water container lid and flip it back.
*
Lift out the water container.
*
Fill the container with (non-carbonated) cold water while observing the
'Max' marking on the water container.
*
Once filled, replace the container in the appliance and push it down in
order to open the valve in the bottom.
*
Close the lid on the water container.
•
The water level must be monitored and, if necessary, the container refilled in good
time.
•
Should the pump have started sucking in air from the empty water container, fill
the water container first with the indicated maximum amount of water. When
'bleeding' the system afterwards, it may take a few moments before water is
emitted again.
•
Deposits of dirt and lime may cause the seals in the outlet at the bottom of the water
container and those around the valves to leak. Check the seals carefully each time the
water container is inserted and, if necessary, carefully remove any existing deposits.
Inserting/removing the filter holder
•
The filter holder is fitted to the appliance by means of a bayonet type locking
socket. When attaching the filter holder, its handle must be facing to the left of the
boiler outlet (a). To lock, turn the filter holder firmly as far as possible to the right
(b), i.e. in an anti-clockwise direction.
6
(a) (b)
Advertisement
