Appendix A Connectors; A1 Application Connectors; A1.1 Surface Mounted; A1.2 Through Hole Mounted - HMS AnyBus DataTransfer Design Manual

Appendix A Connectors

A1 Application Connectors

For the application interface of the ANYBUS DATATRANSFER module a standard male strip connector is
used. Header for this connector can be ordered both as surface or hole mounted.
header for male strip connector
In the following sections the recommended connectors and manufactures are listed.

A1.1 Surface Mounted

Pin length
4.65mm
4.65mm
2.15mm
4.5mm
2.20mm
3.55mm
Table 13. Surface mounted connectors

A1.2 Through Hole Mounted

Pin length
4.44mm
4.5mm
3.55mm
• Available as surface or hole
mounted.
• Also available as 90º connector
Application connector
Order No.
79 109 - 0215
79 109 - 0015
87 340 - 1622
pieces
(2 )
M22 - 634 1622
CLT-116-02-F-D
SMM-116-02-F-D
Application connector
Order No.
79 107 - 0015
M22 - 612 1622
SMM-116-01-F-D
HMS F
IELDBUS
Manufacturer
Molex
Molex
Molex
Harwin
Samtec
Samtec
Manufacturer
Molex
Harwin
Samtec
S AB
YSTEMS
Design Guide
Revision 1.12
1998-08-12
Page 30 (35)