Figure 17 Plunger Attachment; Figure 18 Plunger Position - KEB COMBISTOP 38 Instruction Manual

Optional Components and Accessories
2. Insert the plunger (3) onto the M6 screw (4).
3. Tighten the plunger with an 8mm wrench until there is at least a one inch gap from the
plunger tip to the top of the magnet.
4. Fasten the microswitch wire to the magnet housing via the pipe clip (5). Tighten the bolt
with a 4mm hex head key.
34

Figure 17 Plunger Attachment

Figure 18 Plunger Position

2021 KEB America, Inc.
©