Installation
4.3.2 Design B Installation
4.3.2.1
Disassemble the Brake
The Design B brake comes fully assembled, but must be disassembled prior to
installation.
1. Loosen and remove the three M10 lock-nuts (1) holding the magnet housing on the brake
assembly using a 17mm wrench.
2. Lift the magnet assembly (2) off the mounting studs (3) and set it aside.
3. Remove the hub (4) from the brake assembly (5) and set it aside.
24
i
Do not loosen or remove the two black manual release bolts (if
included) as they hold the magnet together.
Figure 5 Magnet Removal
Figure 6 Hub Removal
2021 KEB America, Inc.
©