Mount The Hub; Figure 8 Hub Installation; Figure 9 Hub Alignment - KEB COMBISTOP 38 Instruction Manual

Installation
4.3.2.3

Mount the Hub

1. The Load Brake contains several friction disks which can freely rotate when the brake is
disengaged or disassembled. Ensure the teeth of each friction disk are all aligned in the
same orientation.
•
→
2. Mount the hub (5) onto the shaft (4) ensuring the hub is oriented with set screws facing
out.
3. Align the hub (5) onto the teeth of the friction disks (7) using the alignment tool (6) to hold
the friction disks steady (if used). Some rotation of the hub may be necessary to align all
of the friction disks if the optional alignment tool is not used.
4. Align the hub axially on the shaft per the brake specifications.
5. Tighten set screws, clamping color or snap rings to secure the hub in place.
26
For ease of assembly an optional alignment tool (6) can be used to hold the friction
disks in place while mounting the hub.
See section Required Tools for details on the alignment tool.

Figure 8 Hub Installation

Figure 9 Hub Alignment

2021 KEB America, Inc.
©