Mount The Brake Assembly; Figure 7 Brake Assembly Installation - KEB COMBISTOP 38 Instruction Manual

Installation
4. Note the orientation of the spring washer stacks (6) on each stud. Ensure the washers do
not fall off during the installation process.
•
4.3.2.2

Mount the Brake Assembly

1. Apply LOCTITE
2. Mount the brake assembly (3) over the shaft (4) and align with the motor (1).
3. Fasten the brake assembly to the gear motor using the mounting bolts (2).
4. Tighten the bolts equally in two stages until the brake assembly is securely fixed to the
motor. KEB recommends a tightening torque of 60 – 80 Nm.
2021 KEB America, Inc.
©
If the washers do fall off the mounting studs, replace them with the first washer cone
up and then alternating directions (<><>).
i
 A piece of tape or similar measure may be used to secure washers to
the mounting studs if the brake must be moved before reassembly.
to the threads on the internal flat head mounting bolts (2).
®

Figure 7 Brake Assembly Installation

25