Unpacking The Brake; Installing The Brake; Design A Installation; Install The Hub On The Shaft - KEB COMBISTOP 38 Instruction Manual

Installation

4.2 Unpacking the Brake

CAUTION
1. Remove the packaging from the brake.
2. Inspect the complete brake assembly for damage or defect.
3. Remove the rubber dust ring, if installed.
4. Remove cardboard packaging strips holding the hub in place.
5. Place the brake on a support such that the weight of the brake does not rest on the
protruding internal mounting bolts (Design B).

4.3 Installing the Brake

4.3.1 Design A Installation

4.3.1.1

Install the Hub on the Shaft.

1. Mount the hub (2) on the shaft (3), positioning the hub 1mm from the mounting surface
(3). Ensure the hub is oriented with set screws facing out.
2. Lock the hub in place axially with a shaft collar or snap rings. Set screws are included for
additional security.
3. The hub should rotate with less than a 0.2mm runout on the hub outer diameter and the
hub face.
The hub should be centered in the brake mounting pattern to less than 0.2mm when
measured from the hub to the six mounting holes.
22
Heavy Objects!
 Large sizes of the Load Brake can be too heavy to safely lift by
hand. Use appropriate lifting equipment to transport the size 10
Load Brake.
i
 Report any shipping damage to the device or packing to the
shipping company and to KEB America, Inc.

Figure 3 Hub Installation

2021 KEB America, Inc.
©