Call Routes; Outbound Routes; Table 60: Outbound Route Configuration Parameters - Grandstream Networks UCM6206 User Manual

Outbound Routes

Outbound Routes
In the UCM6200, an outgoing calling rule pairs an extension pattern with a trunk used to dial the pattern. This
allows different patterns to be dialed through different trunks (e.g., "Local" 7-digit dials through a FXO while
"Long distance" 10-digit dials through a low-cost SIP trunk). Users can also set up a failover trunk to be used
when the primary trunk fails.
Go to Web GUI->PBX->Basic/Call Routes->Outbound Routes to add and edit outbound rules.
•
Click on "Create New Outbound Rule" to add a new outbound route.
•
Click on to edit the outbound route.
•
Click on to delete the outbound route.
•
On the UCM6200, the outbound route priority is based on "Best matching pattern". For example, the
UCM6200 has outbound route A with pattern 1xxx and outbound route B with pattern 10xx configured. When
dialing 1000 for outbound call, outbound route B will always be used first. This is because pattern 10xx is a
better match than pattern 1xxx. Only when there are multiple outbound routes with the same pattern
configured, users can click on
among those outbound routes.
Note: Under Web GUI->PBX->Basic/Call Routes->Outbound Routes -> Country codes section, the UCM
display a list of countries international codes and the administrator can exclude specific countries to be reached.
Calling Rule Name
Pattern
Disable This Route

CALL ROUTES

to move the outbound route up/down to arrange the priority

Table 60: Outbound Route Configuration Parameters

Configure the name of the calling rule (e.g., local, long_distance, and etc). Letters,
digits, _ and - are allowed.
•
All patterns are prefixed with the "_".
•
Special characters:
X: Any Digit from 0-9.
Z: Any Digit from 1-9.
N: Any Digit from 2-9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-9] - Any digit from 1 to 9.
After creating the outbound route, users can choose to enable and disable it. If the
route is disabled, it will not take effect anymore. However, the route settings will
UCM6200 Series User Manual
P a g e | 180