Connecting The Decoder To A   Pre-Amplifier - T+A DD 1535 R Operating Instructions Manual

Connecting the decoder to a 
with TASI and R socket:
LINK
To keep the wiring diagram as clear as possible, only the
integrated amplifier is shown, i. e. not the analogue
source devices. The source
connected as shown in following wiring diagrams.
Complete the wiring of the components as shown in
wiring diagram as follows:
• Connect the TASI interface on the decoder to the
TASI socket on the  pre-amplifier or integrated
amplifier using the TASI lead.
• Connect the R socket on the decoder to the
LINK
R socket on the integrated amplifier.
LINK
All manuals and user guides at all-guides.com
 integrated amplifier  
• Please be sure to connect the pre-amplifier output
devices should be
• Finally connect the mains power supply and switch
38
PRE on the pre-amplifier to the sub-woofer input SUB
IN on the decoder. This improves the signal : noise
ratio of the system, even if the sub-woofer is not used
in standard stereo mode.
Note:
If you are using a pre-amplifier with only one PRE
output, and you have already connected the power
amplifier to this, you can use a Cinch Y-lead adaptor
to gain access to the pre-amplifier signal. Please ask
your specialist  dealer for advice.
the system on.