Table of Contents
Advertisement
Problem:
Neither on-screen menu nor other
external programmes appear on the
TV screen. TV only shows those
stations which are received via its
own aerial.
Video lead not connected properly.
Cause 1:
Push in all connectors firmly.
Remedy:
The
TV
set
Cause 2:
automatically to the AV input.
Remedy:
Set the TV set to 'AV operation' mode.
Problem:
Picture unstable.
Synchronisation signal absent.
Cause:
Push
connector
Remedy:
television to 'AV operation' mode.
Problem:
Monochrome picture only.
Incompatible picture norms set on the
Cause:
TV, the decoder and the source device.
Remedy:
Set TV, decoder and source device to
the same picture norm.
If problems persist, set the decoder to
Note:
the 'RGB / Video' norm; select the
picture norm 'Video', occasionally also
termed 'FBAS' or 'Composite', on the
TV set and the source device.
Problem:
Nothing on the decoder screen.
The screen is switched off.
Cause:
Switch the screen on again in the
Remedy:
'Configuration Menu'.
All manuals and user guides at all-guides.com
does
not
switch
in
firmly,
or
set
60
Problem:
When playing an NTSC-DVD the on-
screen menu is distorted.
The TV set does not feature automatic
Cause:
format detection for NTSC, and has
been set manually to NTSC. The
SR 1535 R's on-screen menus are only
generated in PAL format, so this
operation is not possible.
Use a TV set with automatic PAL /
Remedy:
NTSC format switching, or use the
surround receiver's integral screen.
Problem:
Picture correct, but no sound audible
through the decoder.
No sound connection between source
Cause 1:
device and decoder.
Complete
the
Remedy:
(analogue or digital depending on
mode);
see
'Installation, wiring and using the
system for the first time'.
No sound input, or the wrong sound
Cause 2:
input, has been assigned to the picture
input in the 'Source Setup'.
Check the sound input to which the
Remedy:
source device is connected. Call up the
'Source Setup' and carry out the
correct assignment.
Cause 3:
The loudspeaker is switched off.
Switch on the loudspeaker using the
Remedy1:
button.
Check
that
Remedy2:
switched itself off due to overheating or
a
short-circuit
connection.
Problem:
When
you
programmes, you hear unwanted
noise.
The television set is not capable of
Cause:
muting (silencing) the SCART audio
outputs.
Connect
the
Remedy:
sockets) on the TV set to the pre-
amplifier's TV audio input. In the AUDIO
column of the 'Inputs Menu' you must
now select TV instead of TASI !
This variant on standard wiring is
Note:
possible with all source devices for
which a corresponding pre-amplifier
input is available.
Problem:
Decoder switches off after a certain
period of operation.
Unit is overheating.
Cause:
Remedy:
Make sure that the cooling airflow is
adequate; reduce volume if necessary.
sound
connection
section
entitled
the
decoder
has
not
in
the
loudspeaker
switch
television
audio
output
(Cinch
Advertisement
Table of Contents
