Support Positioning - H3C S9500 Series Installation Manual

Hide thumbs Also See for S9500 Series:

Table of Contents

Installation Manual

H3C S9500 Series Routing Switches

Install anti-static floor supporting

accessories

Figure B-17 Installation flowchart of the B68-22 cabinet (on raised floor)

B.3.3 Support Positioning

I. Planning the cabinet position

Before the installation, first plan the available space. There should be sufficient space

for maintenance and operation at the front and rear doors of the cabinet, as shown in

Figure B-19, Figure B-20 and Figure B-21. At least 800mm clearance is required

around the B68-22 cabinet.

II. Drawing lines

According to the reference dimension and support dimension in the construction plane

design diagram, determine the support installation location, measure several

marking-out points, mark out two lines which are parallel with the reference and whose

spacing is 760mm. According to the design requirements, determine the hole locations

of the first support on the two lines. Then take the hole as the reference point and mark

out the installation holes of other supports one by one. To avoid faults, after being

marked out, all hole location lines should be measured again so as to ensure the proper

dimension. Figure B-18 shows the support installation hole locations, Figure B-19

shows the installation hole locations of a single cabinet, Figure B-20 shows the

Start

Support positioning

Install support

Install slide rail

Level cabinet

Fasten cabinet

Insulation test

Test passed?

Recover floor

End

Appendix B Installation of B68 Cabinet

B-17

Table of Contents