Cabinet Combination Connection - H3C S9500 Series Installation Manual

Installation Manual
H3C S9500 Series Routing Switches
(1) Retaining nut of the cabinet
(3) Retaining nut of anchor plate
Figure B-29 Cabinet feet fastening
B.3.7 Cabinet Combination Connection
When two or more cabinets are to be combined, combination connection between
cabinets should be conducted. As shown in Figure B-30, first remove top covers of all
cabinets, then rotate the combining plates on top of the cabinets by 180° and fasten
them, and use flat washer, spring washer, bolt and nut to combine the combining plates
as shown in Figure B-31. Figure B-30 shows the position of combining plate before it is
rotated, and Figure B-31 shows the its position after it has been rotated.
Appendix B Installation of B68 Cabinet
(2) Cabinet foot
(4) Lower enclosure frame of the cabinet
B-27