Table of Contents
Advertisement
2.5.
Connection to the CAN-gateway (not for Q3 and RNS850)
Set the Gateway free.
Pin diagram
4pin cable
•
Generally:
CAN Low
grey
••
(Audi A6 with deviant connector:
••
•
Generally:
CAN High
blue
••
(Audi A6 with deviant connector:
••
Location of CAN-gateway
• A1/A3
below the steering-wheel
• A6/A7/A8
footwell passenger side below right
(A6 from 2013 middle of rear bench seat)
• Q5
footwell on the passenger side top left
• A5 (8T)
on the left side behind the glove compartment.
Disconnect the female 20pin connector of the factory harness at the
CAN Gateway and connect it to the 20pin connector of the 20-Pin PNP harness.
Connect the opposite female 20pin connector of that 20pin PNP harness
to the previously become free 20-Pin connector of the CAN Gateway.
Note: In case of difficulties with the connection of the 20pin PNP
harness;
the enclosed stripped 4pin harness
upper shown Gateway pin connection.
Version 09.08.2021
Pin diagram
CAN-gateway
Pin 5
orange/grey
Pin 6 orange/brown)
Pin 15
orange/green
Pin 22
orange/blue
(Audi A6)
can be used for the
HW CAM(V31),(V22)
CI-RL2-MMI3G-GW/Q3
Advertisement
Table of Contents
