Connection - Head-Unit - r.LiNK CI-RL2-MMI3G-GW-VW Manual

Note: Check the LEDs on CAN-box after reconnecting the battery, two must be on.
Not all vehicles are kompatible. If the CAN-box does not deliver ACC to pin2 of the video-
interface or blocks the thevehicle's CAN, it is possible to install the video interface without
the CAN-box (analog). In this case see also note in chapter "After-market rear-view
camera". For analogue connection see 6pin assignment above.
2.4. Connection – head unit
Remove the grey
female 4pin HSD connector from the rearside of the factory head unit and connect it
to the aubergine colored male 4pin HSD connector of the picture signal cable.
Connect the waterblue
to the previously become free
or pink coloured!) male 4pin HSD connector of the factory head-unit.
Connect the waterblue
to the male HSD+2 connector of the video-interface.
Note: No liability for vehicle wire colours and pin definition!
Changes by the vehicle manufacturer are possible. The given information has to be verified
by the installer.
Version 09.08.2021
(Depending on the head-unit, possibly also white or
colored female 4pin HSD connector of the picture signal cable
grey (Depending on the head-unit, possibly also white
colored female HSD+2 connector of the picture signal cable
HW CAM(V31),(V22)
pink coloured!)
CI-RL2-MMI3G-GW/Q3