Billion BiPAC 8200AXL-1200 User Manual page 45

Enable IGMP-Proxy: Enable/Disable the IGMP Proxy. If disabled, the IPTV will not work with NAT enabled
mode.
IP Protocol: Setup profile's IP protocol to be IPv4 only, IPv6 only or IPv4/IPv6 dual stack.
When Channel Mode is set to IPoE, you will have the options below.
Type: Setup the WAN interface is use static IP or activate as DHCP client and get WAN IP from ISP.
Local IP Address/Remote IP Address/Subnet Mask: Enter the IP address, subnet mask and gateway address
that provided by your ISP.
Request DNS: If this option is enabled, the device will use the DNS Server IP that assigned from ISP. It is only
work when Type is set to DHCP.
Primary DNS Server/Secondary DNS Server: Input the primary and secondary DNS server if necessary.
When Channel Mode is set to PPPoE, you will have the options below.
Username/Password: Enter the PPPoE username/password that provided by your ISP.
Type: Specify the PPP connection should be always on (Continuous) or only make connection when necessary
(Connect on Demand) or manually to make Connect/Disconnect.
Idle Time (sec): Specify the idle time for disconnecting the PPPoE connection.
Authentication Method: Specify the authentication method for PPPoE connection.
41