Table of Contents
Advertisement
4.22
99$PPCLLABC
Description: Change the CAN bus pair connection configuration into EEPROM.
After setting successfully, all parameters will take effective after system restart.
Syntax: 99$PPCLLABC
99$PPC
LL
A
B
C
Note:
1.
2.
3.
Response:
Valid Command: OK
Invalid command: ERROR
Example:
Command (ASCII): 99$PPC03101
Command (HEX): 39 39 24 50 50 43 30 33 31 30 31
Response: OK
Change the CAN bus pair connection configuration of the 7540D to
"enable CAN bus pair connection" and act as a TCP client.
Note:
1.
This command can only be accepted by 7540D's port 10000.
2.
Supported by
I-7540D CAN-Ethernet Gateway User's Manual (Version 1.8, March/2021)
Command character
number of parameters, here fix to "03"
Enable CAN bus pair connection flag, 0: Disable, 1: Enable
Using TCP or UDP connection; 0: TCP, 1: UDP
Act as a server or client; 0: server, 1: client
When A=0, B and C take no effective
When using UDP connection(B=1), C take no effective
When acting as a TCP client or using UDP method, users need
to set the destination IP address (section 4.23), so that the
7540D can work correctly.
the fi
rmware v1.06 or later.
88
Advertisement
Table of Contents
Troubleshooting
