Changing Hand Of Trim - Assa Abloy Corbin Russwin FE6600 Series Installation Instructions Manual

FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
4

Changing Hand of Trim

Loosen screw (1) and remove interlocking assembly (2). (Figure 15A)
Always wear eye protection while working .
1. Unscrew the lower thru-bolt stud (11) with a
3/8" wrench.
2. Remove mounting plate (6) and mounting
posts.
3. Switch mounting posts (7) so they occupy the
opposite positions on the mounting plate (6).
4. Note the original position of the extension
spring (16) and lower plate (9) in the
escutcheon (14). Unhook the extension spring
from pin (13).
5. Remove spring (16), lower plate (9) and
locking hub (8) assembly together.
6. Detach extension spring (16) from lower plate
(9) and locking hub assembly (8).
7. Flip lower plate on locking hub assembly
spindle so that the spring hole is on the
opposite side.
8. Reattach hook end of spring to lower plate.
9. Unscrew cap screw w/spacer (12) using a 5/32"
Allen wrench.
10. Move to opposite hole and tighten firmly.
11. Rotate lever to position shown in Figure 16 for
desired hand.
12. Tighten retaining nut (10) firmly by hand and
then back off one notch until pattern shown in
Figure 17 appears.
13. Attach bottom of spring (16) (closed loop) to
pin (13). Hold lever horizontal while inserting
locking hub assembly (8) and lower plate (9)
into retaining nut (10) escutcheon with lower
thru-bolt stud (11).
14. Refer to Figure 16: Position hub (4) for required
function and hand, and ensure that spindle
(5) is vertical. Note position of interlocking
assembly hook when positioning hub.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure A
3
10
9
15
12
13
14
11
Bottom
Figure B
Hook
Figure 15
Functions
24, 66
Spindle
Interlocking
Assembly Hook
Figure 16
Figure 17
7
5
4
2
Interlocking
Assembly
8
1
7
16
7
6
30
Hub
FM467 03/20