Table of Contents
Advertisement
General Information
Recommendations for Moving
Note: A minimum of 2" spacing above and
• The appliance is heavy – use extreme care
below the oven to any adjacent items is
when handling!
required for ventilation purposes.
NOTICE
• It is recommended that 3/4" or larger
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
• BE SURE that support for this appliance is
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.
• Use of a hydraulic lift is recommended for
• Only proper equipment should be used to
move products.
• All openings in the wall behind the
• ALWAYS take steps to protect flooring at
the installation location when moving
products.
• Keep appliance area clear and free from
Installation
Site Preparation
• WARNING: DO NOT USE AN
Note: It is recommended that a thorough
site inspection be conducted PRIOR to
unpacking and moving this appliance.
• WARNING: DO NOT use the handle or
oven door to lift the oven. Remove door
before installation to ensure that it is not
used to lift the unit. Make sure pins are
inserted into hinges before removing door
to prevent personal injury to hands and/or
fingers. Do not lift or carry the door by
the handle.
• Confirm available access to adequate
power – see electrical requirements.
12
All manuals and user guides at all-guides.com
(cont.)
material be utilized to create a support
platform for this appliance.
perpendicular to the front facing of the
wall or cabinet before you perform the
installation.
the installation of double oven units.
appliance or in the floor under the
appliance should be sealed.
combustible materials, gasoline and other
flammable vapors.
EXTENSION CORD WITH THIS
APPLIANCE. SUCH USE MAY RESULT IN
FIRE, ELECTRICAL SHOCK OR OTHER
PERSONAL INJURY.
Door Removal
Installation
NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.
2
1
Open door completely. Place pin in pin hole.
Note: Two pins included.
4
Close until pins stop door.
13
1
Remove wooden brace on front of pallet.
3
Remove hinge trim screws. Take off hinge trim.
5
Lift door up and out.
Note: Do not lift door using handle.
Advertisement
Table of Contents
