Installation - Viking Range 6 Series Installation Manual

General Information
Site Preparation
Note: It is recommended that a thorough site inspection be conducted PRIOR to unpacking and moving this appliance.
• Confi rm available access to adequate power—see electrical requirements.
° Single oven units require a 30 amp circuit
° Double oven units require a 50 amp circuit
• Note: A minimum of 2" spacing above and below the oven to any other adjacent items is required for ventilation purposes. DO
NOT install single or double wall ovens side by side or stacked.
•It is recommended that 3/4" or thicker material be utilized to create a support platform for this appliance.
• BE SURE that support for this appliance is perpendicular to the front facing of the wall or cabinet before you perform the

installation.

•Use of a hydraulic lift is recommended for the installation of double oven units. Be careful not to bend lower trim/vent.
•All openings in the wall behind the appliance or in the fl oor under the appliance should be sealed.
•Keep appliance area clear and free from combustible materials, gasoline and other fl ammable vapors.
Installation
1
Remove wooden brace on front of pallet.
3
Close the door until it stops.
2
Open door completely. Rotate door hinge clip as
4
Push in/lift door up/and then out. Repeat for all
10
1
shown in illustration.
doors.