EIP 10560HD-GB Owner's Manual page 4

To remove the back shell and access the voltage selection switch please
carry out the following steps.
• Locate 2 off cap headed bolts on back of unit and remove
• Locate 2 off cap headed studs on right hand side of unit and remove
• Locate 2 off cap headed studs on left hand side of unit and remove
• Locate 4 off cap headed studs on base of unit and remove
• Once studs are removed the back shell will lift off the unit. The unit will
remain free standing once back shell is removed
• The voltage selection switch is located on the rear of the electrical panel
hanging from the fan deck. Choose the correct voltage for the mains
supply your unit will be connected to. WARNING: selecting the incorrect
voltage for the mains supply being used may damage the unit.
• Once correct voltage is selected, place back onto unit
• Re-fit 4 off cap headed bolts to base
• Re-fit 2 off cap head bolts to right hand side of unit
• Re-fit 2 off cap headed bolts to left hand side of unit
• Re-fit 2 off cap headed bolts to rear of unit
• Ensure all bolts are replaced and tightened correctly before moving unit.
Side fixings
BACK SHELL REMOVAL
Rear fixings
Voltage
Selection
Switch
Cover
Base
Page 4 of 16
Drawing : - TPC442
Issue
Date
Voltage
Selection
Switch
: - 2
: - 24/11/16