Table of Contents
Advertisement
Designed for a wide range of applications, the RM85H is a rugged, industrial unit,
which utilizes an energy-efficient compressor and a compact portable design to
provide easy efficient drying.
The RM85 has a number of special features:
•
High efficiency rotary compressor
•
EIPL's "Hot Gas" defrost system
•
Hours run meter
•
Integral pump out system
•
Provision for permanent drainage
•
Robust rotational moulded polyethylene housing
•
Extra long power cord
•
Separate outlets allowing dry air to be ducted
The fan draws the moist air through the cold evaporator coil, which cools the air
below its dew point. Moisture forms on the evaporator coil and is collected in the
condensate tray, which is equipped with a permanent drain. The cooled air then
passes through the hot condenser coil where it is reheated using the same energy
removed during the cooling phase, plus the additional heat generated by the
compressor. The air is, therefore, discharged from the dehumidifier at a slightly
higher temperature with a lower absolute humidity than that which entered.
Continuous circulation of air through the dehumidifier gradually reduces the relative
humidity within the area.
The RM85H dehumidifier is a rugged, reliable drying unit designed to operate
effectively over a broad range of temperature and humidity conditions. An active hot
gas defrost system, controlled by an electronic timer, guarantees positive de-icing,
thereby optimizing operation at low temperatures.
A digital Humidistat is included which allows for precise humidity control. A
programmable display lets you set a specific desired humidity level.
The unit incorporates a rotational moulded polyethylene shell resilient to damage
caused by rough handling.
The unit is fitted with a transformer which will allow the unit to operate on either
110volts or 230volts 1ph 50Hz power supply. The unit is factory set at 110 volts.
All electrical components within the unit are rated for 110volts, for safety reasons.
The unit can easily be adjusted to operate from a 230 volt power supply as follows:
Warning: ensure the unit is switched OFF and isolated form the supply.
The voltage selector switch is located at the rear of the machine – see diagram on
Page 4.
INTRODUCTION
Page 2 of 16
Drawing : - TPC442
Issue
: - 2
Date
: - 24/11/16
Advertisement
Table of Contents
