EIP 10560HD-GB Owner's Manual page 3

Remove the lower screw and swing the cover to one side to reveal the access hole.
The switch lever can be seen through the hole. Using a flat blade screwdriver move
the switch lever down to the 230 volt position. (If 110 volt is required the switch lever
must be in the upper position)
Once the required voltage has been selected, refit the cover and tighten the lower
fixing screw.
The dehumidifier is now ready to be connected to the required power supply.
Page 3 of 16
Drawing : - TPC442
Issue : - 2
Date : - 24/11/16