NordicTrack Apex 4500 User Manual page 8

4. Orient the Latch Housing (34) so the large hole
is on the indicated side. Attach the Latch
Housing to the left Upright (20) with two Screws
(7); start both Screws before tightening either
of them.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Next, insert the pin into the Latch
Housing (34). Then, tighten the knob onto the
pin.
5. With the help of a second person, raise the
Walking Platform (15) to the storage position and
make sure that the latch pin is engaged as de-
scribed on page 21.
Position the Base Plate (75) on the treadmill as
shown. Attach the Base Plate to the Uprights
(20) with three Base Plate Bolts (77). Note: It
may be helpful if a second person tips the tread-
mill slightly as you tighten the Base Plate Bolts.
Carefully lower the Walking Platform (15) to the
floor as described on page 22.
6. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 24). To protect the floor or car-
pet from damage, place a mat under the treadmill.
All manuals and user guides at all-guides.com
8
4
34
Knob
7
Large Hole
5
15
77
75
20
Spring
Collar
Pin
20