NordicTrack Apex 4500 User Manual page 7

2. With the help of a second person, carefully raise
the Uprights (20) to the vertical position.
Remove the band securing the Upright Wire
Harness (73) to the right Upright (20). Have a
second person hold the console assembly near
the right Upright.
Connect the Upright Wire Harness (73) to the
console wire extending from the console assem-
bly. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Then, insert the connectors into
the right Upright (20).
3. Carefully set the console assembly on the
Uprights (20) as shown. Make sure that no
wires are pinched. Attach the console assem-
bly with four Handrail Bolts (72) and four Star
Washers (67). Start all four Handrail Bolts be-
fore tightening any of them.
All manuals and user guides at all-guides.com
7
2
Console Wire
73
20
3
Console Assembly
67
20
Console
Assembly
73
72
67