Espressif ESP8266 Manual page 18

#
�� Note:
The default baud rate of ESP8266 is 74880. But to use AT commands, the baud rate should be 115200.
3. Power up the ESP-Launcher by toggling the switch "1" to the upper side. Check if the
startup logs (baud rate 74880) are displayed on the SecureCRT.
#
4. User can connect / disconnect the serial port by clicking these two buttons
#
The left button is to create a serial port connection.
•
The right button is to abort the connection.
•
Espressif
Figure Ⅰ-7. Startup Logs
at the upper left corner of the SecureCRT.
15 19 # /#
Appendix I
2016.09