Table of Contents
Advertisement
5.2.8. RECEIVER UPGRADE - OAD
Over Air Download (OAD): To
ensure that your DTR always has the
most up to date information. Please
ensure that after use it is set to its
standby
mode.
automatically powers up at 3.00 A.M.
each day and searches for any new
information which may be broadcast
and will download this to your DTR
automatically.
This
normally
take
approximately
minutes. If you have an important
recording to make at 3.00 A.M. which
must not have a 30 minutes interrupt
then you can disable the auto OAD
search by performing the following:
Ø Press Menu and using "5/6" on the remote control to choose Setup and press OK.
Ø Highlight Configuration menu using "5/6" and pres OK on the remote control.
Ø Use "5/6" to choose "RECEIVER UPGRADE" and press OK on the remote control.
Ø Using "3/4" on the remote control to change "Automatic scanning"
Disabled.
Ø Highlight "Scan for upgrade" menu using "5/6" and press OK on the remote control to
commence upgrade.
Do not forget to re-enable the automatic OAD function after you have made your recording by
repeating the above instructions but this time selecting ENABLE.
5.2.9. PARENTAL LOCKING
Use "5/6" on the remote control to go to Parental
Lock option. Press OK on the remote control to enter
the menu. A box asking for the PIN code is
displayed. This pop-up is set to "0000" initially. Enter
the PIN code. If it is incorrect, "Wrong Pin" is
displayed. If it is correct, the Parental Control Menu
is displayed.
5.2.9.i. MENU LOCK
In menu lock you can set locking for All Menus, or the Installation Menu to restrict access to these
menu's. If the menu lock is disabled, there will be free access to the menu system. Use "5/6" on the
remote control to go to Menu Lock option. Use "3/4" on the remote control to choose Menu Lock
Mode.
DISABLED : All menus are unlocked.
ALL MENUS : All Menus are accessible only with the correct lock button.So the user can't add,
delete, rename, channels, can't set timers.
INSTALLATION MENU : Installation menu is locked.So the user can't add channels. Changes will be
updated after exiting 'Configuration Menu'.
5.2.9.ii. SET PIN
To change the PIN code for this unit. Use "5/6" on
the remote control to go to "Set PIN" option. Press
OK to display the "Set PIN" window. Use NUMERIC
buttons to enter new pin code you will need to input
your new pin a second time for verification purposes.
If Both pin codes are four digits long and the same,
the pin will be changed. The factory default pin code
The
DTR
operation
will
30
27
from Enabled to
Advertisement
Table of Contents
