Table of Contents
Advertisement
5.2. CONFIGURATION
You can configure the settings of
your DTR. Select Configuration from
Setup menu and press OK to enter
this menu. Press BACK on the
remote to exit.
5.2.1. TV TYPE
Digital terrestrial television channels
can broadcast programmes in a
widescreen format which must be
output differently to normal and
widescreen TV sets. This function
tells the receiver the screen format of
the TV connected so that broadcasts
are displayed correctly.Highlight the
TV Type line in the Configuration
menu and use "3/4" to select "4:3" if you have a standard TV set connected or "16:9" if it is a
widescreen TV. If you choose "Auto", the TV type will be set automatically according to the
broadcasted programme. This function duplicates the selection made at the time of first installation
and can be used if you change TV sets.
5.2.2. TV OUT
The receiver can output RGB , CVBS and S-Video signal from the TV SCART on the rear panel.
Although the RGB format results in a better quality picture, not all equipment can cope with an RGB
signal.
5.2.3. VCR OUT
This allows you to select CVBS or S-Video output from the VCR SCART socket.The receiver can
output S-Video and CVBS signal from the VCR SCART on the rear panel.
5.2.4. LOW POWER OPTION
If you select YES, low power mode will be activated. In low power mode the power consumption is
less then 3 W (in standby). The front display will show no time information (in standby). If low power
mode is deactivated, all functions will be reactivated.
5.2.5. FAVOURITE MODE
This function enables or disables the 5 favourite channel list mode by pressing "3/4" . If a favourites
list exists it will switch to the list number selected. If there is no favourite listing, a warning message is
displayed.
5.2.6. CHANNEL LIST
Use "5/6" to go to Channel List option. Use "3/4" to toggle Channel List Mode. If you select "TV
Only" you navigate through only TV channels, if you select "Radio Only" you navigate through only
radio channels, if you navigate "Text Only" you navigate through only Text channels using PR+ / PR-
on the remote control. If you choose "Show All" all, channels can be navigated using PR+ / PR- on the
remote control. To save the recent changes and exit, press MENU on the remote control.
5.2.7. SCAN ENCRYPTED CHANNELS
Use "▲ / ▼" to go to the Scan Encrypted Channels option. Use "◄ / ►" to toggle YES or NO the
searching for encrypted channels.
26
Advertisement
Table of Contents
