Receiver Upgrade - Oad; Parental Locking; Menu Lock; Set Pin - Sharp TU-R160HA Operation Manual

5.2.7. RECEIVER UPGRADE - OAD

Over Air Download (OAD): To ensure
your DTR always has the most up to date
information, please ensure that after use
the unit is set to standby mode. The DTR
automatically powers up at 3.00 A.M. each
day and searches for any new information
which may be broadcast and will download
this to your receiver automatically. This
operation will normally take approximately
30 minutes. If you have an important
recording to make at 3.00 A.M. which must
not have a 30 minutes interrupt then you
can disable the auto OAD search by
performing the following:
Ø Press Menu button and using the
"5/6" buttons to choose Setup
and press the OK button.
Ø Highlight Configuration menu with "5/6" keys and pres OK.
Ø Use "5/6" buttons to choose "RECEIVER UPGRADE" and press OK button.
Ø Using the left / right button change "Automatic scanning" from Enabled to Disabled.
Ø Highlight "Scan for upgrade" menu with "5/6" keys and press OK to commence upgrade.
Do not forget to enable the automatic OAD function again, after you have made your recording by
repeating the above instructions, but this time selecting ENABLE.

5.2.8. PARENTAL LOCKING

Use "5/6" buttons to go to Parental Lock option.
Press "OK" button to enter the menu. A box asking
for the lock key is displayed. The key is set to "0000"
initially. Enter lock key. If it is incorrect, "Wrong Pin"
is displayed. If it is correct, the Parental Control
Menu is displayed.
5.2.8.i. MENU LOCK
In menu lock you can set lock for All Menus, or the Installation Menu to restrict access to these
menu's. If the menu lock is disabled, there will be free access to the menu system. Use "5/6" buttons
to go to Menu Lock option. Use "3/4" buttons to choose Menu Lock Mode. Please write the PIN
number at the last page of your instruction book, to keep it safe.
DISABLED : All menus are unlocked.
ALL MENUS : All Menus are accessible only with the correct lock key.So the user can't add, delete,
rename channels, can't set timers.
INSTALLATION MENU : Installation menu is locked.So the user can't add channels. Changes will be
updated after exiting 'Configuration Menu'.
5.2.8.ii. SET PIN
To change the PIN code of the unit, use the "5/6"
keys to go to "Set PIN" option. Press "OK" to display
the "Set PIN" window. Use "NUMERIC" keys to enter
new pin code you will need to input your new pin a
second time for verification purposes. If both pin
codes are four digits long and the same, the pin will
be changed. Write the PIN code on page 27. If you
forget your PIN refer to the trouble shooting guide on
page 28. The factory default pin number is 0000, if you change the pin number make sure you write it
down and keep it safe.
22