Hard Disk Info - Sharp TU-R162H Operation Manual

5.1.4. HARD DISK INFO

To view the details about the Hard disc,
highlight "Hard Disk
"(up)/(down)" buttons and press OK. The
following information will be shown:
Total Space: The total size of the Hard
Drive.
Reserved for timeshift: This is the space
that is reserved for use by the timeshift
function and is dependant on the setting
in "Max timeshift".
Space used by recordings: The space
used by the recordings that are on the Hard Drive
Free Space: Available space for future recordings.
Estimated space for times set: The estimated space on the hard drive that will be used for the any
timers that are currently set.
Estimated Recording Time remaining: This is the estimated remaining time left available for
recordings. The settings of the recordings are configured in this menu, press OK to display the menu.
This Recorder has a built in hard disk (abbreviated as HDD) for recording and playback. Beware of the
following points when setting up and using the Recorder. Failure to observe precautions may cause
damage to the HDD itself or its content, failure of the disk to operate, or recording of noise.
·
Do not subject the Recorder to any vibration or impact.
·
Do not place the Recorder in a cramped location which might block ANY of the ventilation
ports located on the Recorder.
·
Do not place the Recorder in a location with severe temperature variation.
Ø If the Recorder is set up in a location with severe temperature variation, dew may form
on and inside the Recorder. If the Recorder is used with internal dew formation
present, this may cause HDD damage or malfunction. We recommend keeping
variation in room temperature within 10˚C per hour.
·
Do not place the Recorder in a location with high humidity.
·
Place the Recorder horizontally, never at an incline.
·
Do not place a magnetic device (magnet, etc.) close to the recorder.
·
When the power is on, do not unplug the power cord from the AC outlet, turn off the breaker
for the area where the Recorder is set up, or move the Recorder.
·
When moving the Recorder, first turn off the power and then unplug the power cord from the
AC outlet.
Info..." using
24